High Speed Laminating Hot Melt Coating Machine mainly used in pressure sensitive adhesive coating, such as self-adhesive label, heat sensitive label, adhesive tapes, advertisement inkjet material, etc.
1 According to the requirements of the process sheet, the base material of the bag to be bagged is installed at the center of the loading shaft by a hydraulic vehicle, and the air-expansion shaft is inflated with a pneumatic gun. Start the air pressure lifting device to place the substrate in the appropriate discharge position. Check the roll substrate for product defects and strips. If it is necessary to keep in mind the joint position, in order to eliminate defective products during the bag making process.
2 Correctly dressing.
3 After the material is finished, the heat-sealing tool that meets the product requirements can be replaced according to the requirements of the process.
4 Turn on the main power, cooling water, static elimination device and compressed air source. According to the process requirements, set the appropriate temperature of the corresponding heat sealing knife through the operation interface.
5 Set the discharge tension air pressure and put it into automatic.
6 Through the spot button, the material is sent to the cut position required by the process sheet, and the length of the bag is adjusted to track the sensitivity of the electric eye. If punching is required, adjust the position of the rounded hole and the tearing opening.
7 Through the man-machine interface, set the bag size according to the requirements of the process sheet, the bag feeding speed, the quantity of finished products and the sealing ratio
Tape Making Machine
1 After everything is ready, start the device and start making bags.
2 For the first batch of equipment, the product should be inspected for the length error of the finished bag, the heat seal strength, and the detection that may affect the quality of the product.
3 Put the qualified products into the finished box, and put the certificate on the outside of the finished box, then seal it into the warehouse with tape.
4 When the machine is in operation, always pay attention to changes in equipment, such as temperature and pressure. And clean the surface of the equipment at any time. It is strictly forbidden to stack the waste anywhere. 30 minutes before leaving work, the assistant will clean the equipment around, otherwise the successor will not take over.
5 Equipment failure, especially electrical faults, should be promptly reflected to the bag shift monitor, fill out the "equipment failure repair order" and notify the maintenance personnel.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc