Tape Packaging Machine

Tape Packaging Machine

make clear & color & printed big jumbo roll from bopp film and glue on same machine by one step.

Tape Packaging Machine

Tape Making Machien

 

Protection management regulations:

Article 3
The tape machine protection installation must meet the following requirements:

1. Install at least one protection device for preventing slippage in each belt conveyor. The main conveyor belt conveyor of the mine, the centralized conveyor belt conveyor, and the comprehensive protection of the belt conveyor should be installed in the driving department. Anti-slip protection can be installed on the tail roller or guide roller. The anti-skid protection should adopt speed sensor or other reliable protection form;
2. At least 2 sets of coal protection shall be installed at each receiving point of the main transport belt conveyor, centralized transport belt conveyor and slotted belt. At least one set of piles shall be set for the belt conveyor, the head of the comprehensive belt conveyor and the receiving point of the tail. Coal protection, coal storage protection should be inclined proximity switch or ground resistance protection;

Tape Packaging Machine

Tape Making Machien

 

Protection management regulations:

Article 3
The tape machine protection installation must meet the following requirements:

6. All belt conveyors drive the drum section and the tail drum to install an over-temperature and automatic smoke sprinkler, and must be installed near the drum to ensure that the automatic sprinkler can effectively extinguish the fire in the event of fire; the water supply system is guaranteed to be unblocked, and no artificial shutdown is allowed. .
Temperature Sensor Installation Standard A temperature sensor is required at each drive roller. The temperature sensor should be mounted along the middle (axial) of the drive roller, 100 mm from the roller surface.
Smoke sensor installation standard For the belt conveyor using the unloading roller as the driving roller, the smoke sensor should be installed directly above the drum, no more than 1000mm from the surface of the drum; for the ordinary driving belt conveyor, the smoke sensor should be installed on the upper roller The middle position of the frame is 1000mm behind the lower air flow side driving roller.
Offset installation requirements: The action point of the deviation switch is not more than 50MM from the outer edge of the idler on the belt conveyor. The deviation between the deviation and the belt surface is 90 ° ± 5 °; the deviation switch must be fixed with a special shelf and must not be swung;

 

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com