Adhesive Tape Testing Machine

Adhesive Tape Testing Machine

Packaging bopp packing clear brown adhesive tape jumbo roll production line making coating machine.

Adhesive Tape Testing Machine

Tape Making Machine

 

Production debugging:
1 According to the requirements of the process sheet, the base material of the bag to be bagged is installed at the center of the loading shaft by a hydraulic vehicle, and the air-expansion shaft is inflated with a pneumatic gun. Start the air pressure lifting device to place the substrate in the appropriate discharge position. Check the roll substrate for product defects and strips. If it is necessary to keep in mind the joint position, in order to eliminate defective products during the bag making process.

2 Correctly dressing.


3 After the material is finished, the heat-sealing tool that meets the product requirements can be replaced according to the requirements of the process.


4 Turn on the main power, cooling water, static elimination device and compressed air source. According to the process requirements, set the appropriate temperature of the corresponding heat sealing knife through the operation interface.

5 Set the discharge tension air pressure and put it into automatic.


6 Through the spot button, the material is sent to the cut position required by the process sheet, and the length of the bag is adjusted to track the sensitivity of the electric eye. If punching is required, adjust the position of the rounded hole and the tearing opening.


7 Through the man-machine interface, set the bag size according to the requirements of the process sheet, the bag feeding speed, the quantity of finished products and the sealing ratio

Adhesive Tape Testing Machine

Tape Making Machine

Article 5
In order to facilitate the maintenance and repair of the equipment, a pedestrian crossing bridge is set every 300 meters when the belt conveyor transport length exceeds 300 meters. In case of special circumstances, additional bridges must be added. The bridge setting must meet the following requirements.
1. Handrails must be provided on both sides of the top of the bridge. The height of the handrail is not less than 700mm. When the height of the bridge deck is greater than 1700mm, the ladders on both sides of the bridge should be set with handrails of not less than 500mm.
2. The effective width of the pedestrian passage of the bridge is not less than 600mm.
3. The distance from the bottom of the bridge to the center of the upper deck is not less than 600mm. The belt conveyor of 1m or more is not less than 800mm, but it is necessary to ensure the large coal and vermiculite pass smoothly according to the actual situation on site.
4. The four legs of the bridge and the roadway floor must be fixed firmly. At the same time, it must be fixed firmly with the belt machine frame. When installing the bridge in the inclined roadway, there must be a reliable anti-fall device.
5. The pedals of the bridge should be made of patterned steel plates or take anti-slip measures.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com