Printed Tape Machine

Printed Tape Machine

It is mainly used for proucing kinds of medical tape which are coating zinc oxde hot melt pressure sensitive adheive on silicon paper/glassine paper/ginning membrance, then laminate with cartoon PE/spun-laced non-woven fabric/cotton. or coat adhesive on kinds of substrate directly.

Printed Tape Machine

Tape Making Machine

 

Production debugging:
1 According to the requirements of the process sheet, the base material of the bag to be bagged is installed at the center of the loading shaft by a hydraulic vehicle, and the air-expansion shaft is inflated with a pneumatic gun. Start the air pressure lifting device to place the substrate in the appropriate discharge position. Check the roll substrate for product defects and strips. If it is necessary to keep in mind the joint position, in order to eliminate defective products during the bag making process.

2 Correctly dressing.


3 After the material is finished, the heat-sealing tool that meets the product requirements can be replaced according to the requirements of the process.


4 Turn on the main power, cooling water, static elimination device and compressed air source. According to the process requirements, set the appropriate temperature of the corresponding heat sealing knife through the operation interface.

5 Set the discharge tension air pressure and put it into automatic.


6 Through the spot button, the material is sent to the cut position required by the process sheet, and the length of the bag is adjusted to track the sensitivity of the electric eye. If punching is required, adjust the position of the rounded hole and the tearing opening.


7 Through the man-machine interface, set the bag size according to the requirements of the process sheet, the bag feeding speed, the quantity of finished products and the sealing ratio

Printed Tape Machine

Tape Making Machine

 

Article 2
All units must carry out number management on the belt joints of the belt conveyor. In addition to the daily inspections, the belts are thoroughly inspected and recorded every week, and problems are found to be dealt with in a timely manner.


Article 3

All steel wire ropes must be inspected regularly. The inspection is carried out by a special person. The period is one month. After the flaw detection, a flaw detection report must be issued and the bottom is required. The belt conveyor roller inspection company issued the belt conveyor flaw detection. Management Measures (Trial).

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com