Automatic Tape Edge Machine

Automatic Tape Edge Machine

It is mainly used for proucing kinds of medical tape which are coating zinc oxde hot melt pressure sensitive adheive on silicon paper/glassine paper/ginning membrance, then laminate with cartoon PE/spun-laced non-woven fabric/cotton. or coat adhesive on kinds of substrate directly.

Automatic Tape Edge Machine

Tape Making Machine

 

Start production
1 After everything is ready, start the device and start making bags.
2 For the first batch of equipment, the product should be inspected for the length error of the finished bag, the heat seal strength, and the detection that may affect the quality of the product.
3 Put the qualified products into the finished box, and put the certificate on the outside of the finished box, then seal it into the warehouse with tape.
4 When the machine is in operation, always pay attention to changes in equipment, such as temperature and pressure. And clean the surface of the equipment at any time. It is strictly forbidden to stack the waste anywhere. 30 minutes before leaving work, the assistant will clean the equipment around, otherwise the successor will not take over.
5 Equipment failure, especially electrical faults, should be promptly reflected to the bag shift monitor, fill out the "equipment failure repair order" and notify the maintenance personnel.

Automatic Tape Edge Machine

Tape Making Machine

 

Article 4
The receiving point of the tape machine must use a buffer bed or other cushioning device to prevent the sharp tape or hard object from tearing the tape. The installation requirements are as follows:
1. The production of the guide groove of all belt conveyors must be standardized, the welding is firm and reliable, the height of the coal is guaranteed to be more than 1 meter, and the lower mouth of the slip nozzle should be smooth, so as to improve the passage of coal flow and prevent large coal or The meteorite caused the tearing accident due to the fact that the guide material was not smoothly caught in the guide groove.
2. Install a set of buffer beds (ie, the installation length is 1.2 meters) at each receiving point. The distance between the surface of the buffer strip and the belt surface shall not be less than 20~30mm, to prevent the surface from sinking due to the long installation length. Increase the wear on the belt surface; the installation clearance between the buffer strips shall not exceed 10 mm, and the gap shall be filled after installation to prevent the iron piece or large piece of coal and vermiculite from penetrating the belt between the gaps of the buffer strip, resulting in Tear the accident.
3. The operation team shall formulate the management system of coal bunker, slip coal eye, and distribution bar scraper (cast stone slab). The bunker must be equipped with anti-smashing bin protection device to prevent coal slip directly from impacting the bottom shrinkage plate and I-beam. Causes deformation and shedding, mixing into the coal slip causes tearing accident.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com