Ptfe Tape Slitting Machine

Ptfe Tape Slitting Machine

suitable for cutting PVC tape,masking paper tape,double sided tape,kraft tape,conductive foam tape,duck tape,protective film, etc.

Ptfe Tape Slitting Machine

Tape Making Machine

 

Production debugging:
1 According to the requirements of the process sheet, the base material of the bag to be bagged is installed at the center of the loading shaft by a hydraulic vehicle, and the air-expansion shaft is inflated with a pneumatic gun. Start the air pressure lifting device to place the substrate in the appropriate discharge position. Check the roll substrate for product defects and strips. If it is necessary to keep in mind the joint position, in order to eliminate defective products during the bag making process.

2 Correctly dressing.


3 After the material is finished, the heat-sealing tool that meets the product requirements can be replaced according to the requirements of the process.


4 Turn on the main power, cooling water, static elimination device and compressed air source. According to the process requirements, set the appropriate temperature of the corresponding heat sealing knife through the operation interface.

5 Set the discharge tension air pressure and put it into automatic.


6 Through the spot button, the material is sent to the cut position required by the process sheet, and the length of the bag is adjusted to track the sensitivity of the electric eye. If punching is required, adjust the position of the rounded hole and the tearing opening.


7 Through the man-machine interface, set the bag size according to the requirements of the process sheet, the bag feeding speed, the quantity of finished products and the sealing ratio

Ptfe Tape Slitting Machine

Tape Making Machine

 

Article 4
The receiving point of the tape machine must use a buffer bed or other cushioning device to prevent the sharp tape or hard object from tearing the tape. The installation requirements are as follows:
1. The production of the guide groove of all belt conveyors must be standardized, the welding is firm and reliable, the height of the coal is guaranteed to be more than 1 meter, and the lower mouth of the slip nozzle should be smooth, so as to improve the passage of coal flow and prevent large coal or The meteorite caused the tearing accident due to the fact that the guide material was not smoothly caught in the guide groove.
2. Install a set of buffer beds (ie, the installation length is 1.2 meters) at each receiving point. The distance between the surface of the buffer strip and the belt surface shall not be less than 20~30mm, to prevent the surface from sinking due to the long installation length. Increase the wear on the belt surface; the installation clearance between the buffer strips shall not exceed 10 mm, and the gap shall be filled after installation to prevent the iron piece or large piece of coal and vermiculite from penetrating the belt between the gaps of the buffer strip, resulting in Tear the accident.
3. The operation team shall formulate the management system of coal bunker, slip coal eye, and distribution bar scraper (cast stone slab). The bunker must be equipped with anti-smashing bin protection device to prevent coal slip directly from impacting the bottom shrinkage plate and I-beam. Causes deformation and shedding, mixing into the coal slip causes tearing accident.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com