Mini Bopp Coating Machine

Mini Bopp Coating Machine

1. Moveable blade device. 
2. Guiding roller in oven will synchronously rotates with main shaft. 
3. Solenoid operated valve controlling is adopted for Anilx roller and drawing roller. 
4. Automatic meter-measuring devices. 
5. Key mode air shaft is used for unwinding and rewinding shafts, easy to load and unload. 

Mini Bopp Coating Machine

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Mini Bopp Coating Machine

Coating Machine - Process flow

 

Fifth, the common problems of coating and treatment methods:

13. The coating tension is set at 1.8 and the negative is set at 2.8.
14. When the thickness is not uniform, adjust the distance between the scraper and the test roll.
15, the front and back are inconsistent, adjust the coating length and tracking coating length.
16. The tension of the initial roll diameter should be adjusted each time the roll is changed.
17. Rounding or other issues are well marked.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com