Mini Coating Line

Mini Coating Line

It's be mainly used for bopp film gelatinizing producing,The tape is mainly used to seal the box, seal the cover and bind the articles, and can also be used as office supplies.

Mini Coating Line

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Mini Coating Line

Coating Machine - matters needing attention

 

1. The maximum temperature of the positive electrode coating should not exceed 125 oC on one side. The single surface is not easy to dry. The non-stick roller is the standard. The reverse speed is slow and thoroughly dried.
2. The temperature of the single side of the negative electrode should not exceed 105 oC, and the temperature of double coating should not exceed 110oC.
3. The coated pole piece must be completely baked. If it does not dry or has the phenomenon of stripping, the temperature of the temperature zone can be properly adjusted, the temperature can be lowered, the pole piece can be stripped, the temperature can be lowered, and the temperature can be raised.
4. The density is adjusted by adjusting the screw.
5, the thickness is adjusted by adjusting the screw, so that the two sides reach a consistent speech.
6. Adjust the speed and temperature to achieve the best coating.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com