Acrylic Adhesive Coating Line

Acrylic Adhesive Coating Line

Suiable for common PET/double-side tape/bopp tape/foam tape/paper sereis/pe protective film.

1.     Automatic tension control.
2.     Gravure coating or semiflexo coating.
3.    Drying tunnel with sectional temperature control and recirculation adjustment.
4.    Steel idle rollers inside the drying hood driven by independent motor.
5.     Inner stainless steel frame covers of the coating section.
6.     preading roller driven by independent motor,positioning pneumatically.

 

Acrylic Adhesive Coating Line

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Acrylic Adhesive Coating Line

Coating Machine - matters needing attention

7. When adjusting the gap between the coating roller and the back roller, the slurry on the coating roller should be wiped off without sticking the back roller. The parallel and the gap of the two rollers must be consistent (there must be a gap).
8. Immediately after each shift, clean the hopper, scraper, coating roller and back roller with alcohol or acetone. The surface must not be scratched or damaged.
9. Pay attention to keeping the back roller cylinder and linear slide clean and lubricated.
10. The bearing parts of the machine must be lubricated regularly, and the gear box must be changed or replenished regularly.
11. Once problems are found during the operation, they must be recorded and notified to the relevant departments for timely processing.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com