Seal Tape Coating Machine

Seal Tape Coating Machine

1.  150m/min high speed has already reached the international most advanced level.

2.   Rewind and unwind both adopt double position and equip with semi-automatic to connect paper device, The machine can change the rolls of base material nonstop, It will reduce the waste.

3.   When the double sides adhesive tape coat twice, it will effect the quality of products, but the technology of double sides coating meanwhile will solve the questions.

Seal Tape Coating Machine

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Seal Tape Coating Machine

Coating Machine - Head inspection items:

1, foil tape inspection, must meet the process standards.
2, the pole piece has a leaky foil, and the shutdown is clean.
3, there are scratches in several consecutive sections, and clean in time.
4. There are scratches on the guide roller, and the machine is wiped clean.
5, the gap is not parallel for several consecutive sections, stop adjustment.
6, tracking, gap, coating length is not accurate, stop adjustment.
7. The foil strip runs around and checks whether the correction is in the servo state.
8. The edge of the pole piece is too wide and has no edge, and the baffle plate is adjusted.
9. Always ensure that the hopper's slurry is full.
10. After the operation is completed, thoroughly clean the machine head.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com