Seal Tape Gluing Machine

Seal Tape Gluing Machine

1.  150m/min high speed has already reached the international most advanced level.

2.   Rewind and unwind both adopt double position and equip with semi-automatic to connect paper device, The machine can change the rolls of base material nonstop, It will reduce the waste.

3.   When the double sides adhesive tape coat twice, it will effect the quality of products, but the technology of double sides coating meanwhile will solve the questions.

Seal Tape Gluing Machine

Coating Machine - Process flow

Third, the coating process
1. The staff wears labor insurance products.
2. Check if the scraper, test roller, guide roller and back roller are wiped clean. 3. Wear the leash in the stopped state.
4. Turn on the main power supply, servo motor, drying fan and other switches.
5. Fix the empty foil material of the positive and negative poles and pull them to the oven to connect them with the traction belt.
6. Install the trough and baffle, pour the selected slurry into the hopper and fill the slurry. 7. Set the coating temperature, speed, speed ratio and coating tension on the controller according to the following table.
8. Set the coating working mode in the control interface, and adjust the parameters according to the process requirements.
9. When coating, press “Test” twice, then press “Coating”. When testing, generally apply 3-5 sections of traction to the oven to dry it.
10. After the test piece is taken back to the machine head, the density of the pole piece is measured, the length is coated,
Relevant parameters such as width, clearance and thickness. If it does not meet the process requirements, it will be modified to meet the process standards.
11. Start coating after trying the film, and check it at any time during the coating process.
Whether there are particles on the pole piece, scratches on the surface, bubbles, and signs.
12. After the first side is applied, adjust the parameters according to the process requirements. After the temperature is stable, start coating the second side.
13. During coating, the density, coating length and gap of the first side and the second side should be measured at any time and recorded.
14. When the coating is stopped, first press “Coating Control Stop” and open the “Test” button at the same time.
15. Press the “Emergency Stop” button if you encounter an emergency during the coating process.
16. The coated pole piece should be placed on a special iron frame and marked with the mark, and transferred to the next process.
17. Stop the machine when the coated pole piece has been wound up.
18, turn off the device heater power, until the temperature of each segment drops to 60 degrees Celsius
When the temperature is below, stop the drying fan and other machines.
19. Shut down according to the requirements of the equipment operation rules, and clean the coating roller, scraper and utensils with alcohol.
20. Turn off the main power supply.

Seal Tape Gluing Machine

Coating Machine - Process flow

 

Fifth, the common problems of coating and treatment methods:

13. The coating tension is set at 1.8 and the negative is set at 2.8.
14. When the thickness is not uniform, adjust the distance between the scraper and the test roll.
15, the front and back are inconsistent, adjust the coating length and tracking coating length.
16. The tension of the initial roll diameter should be adjusted each time the roll is changed.
17. Rounding or other issues are well marked.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com