Coating Equipment For Bopp Tape

Coating Equipment For Bopp Tape

1. High precision alloy steel die head make sure the customer can get the best coating effection.

2. Total Machine is controlled by  PLC.Precision control coating speed and glue amount.

3. Increase the film function in some glue or substrate is not suitable for direct knife coating that realize 2 kinds of craftwork (knife coating and film coating.) on one machine.

Coating Equipment For Bopp Tape

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Coating Equipment For Bopp Tape

Coating Machine - Process flow

Fourth, the process requirements: positive and negative electrode coating:
Foil requirements: aluminum foil: (degree × width) 18um × 500 (±1.0) mm areal density: 0.48 ± 0.02g / 100cm2 copper foil: wool foil: (degree × width) 9um × 500 (± 0.5) mm areal density: 0.98±0.04 g/100cm2 Light foil (degree×width) 9 um×500(±0.5)mm Area density: 0.87±0.04 g/100cm2
4 coating standards:
Dressing density:
positive electrode;
First dressing density: ±0.02g/100 cm2
Second dressing density: ±0.02g/100 cm2 Double-sided total dressing density: ±0.04 g/100 cm2
Negative electrode:
First dressing density: ±0.015 g/100 cm2 First dressing density: ±0.015 g/100 cm2

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com