Bopp Printed Tape Coating Line

Bopp Printed Tape Coating Line

1. Main engine with glue pump track together, operate manual control alone too.

2. Use import intelligent PID temperature system, stabile temperature and error in 1 °c.

3. Multi rool enlarge cooling installation, enlarge base material use range, improve produce speed.

4. Independent research and development of high precision metering pump with high precision alloy steel die, realized the high quality coating effect.

Bopp Printed Tape Coating Line

Adhesive Tape Coating Machine operation process:
1. Prepare before starting up
1) Check each electrical switch for any abnormalities such as falling off or damage.
2) Wear the traction belt at the normal temperature stop condition according to the requirements of the process piece.
3) Start the exhaust unit.
4) Confirm that there is no open flame in the coating machine room.
5) The coater control cabinet and the drying cabinet housing must be reliably grounded.
1.2 boot program
1) Close the main power switch and the power switch on the control cabinet.
2) Set the initial value (usually 180 to 280) and the division ratio on the tension controller.
3) Set the coating working mode and related parameters (coating speed, section length, gap length, roll speed ratio, etc.), and then turn on the compressed air;
4) Start the drying fan and the drying temperature controller.
5) Turn on the automatic deskew and tension controller power.
6) The temperature of each section of the equipment has reached the required temperature of the process;
7) Feed the coating device hopper while starting the coater for coating.
1.3 shutdown procedure
1) Confirm that the coated pole piece has been wound up and then stop.
2) Turn off the heater power of the equipment and stop the drying fan and other fans when the temperature of each section drops below 60 degrees Celsius;
3) Stop the compressed air.
4) Disconnect power from the correcting cabinet and control cabinet.

Bopp Printed Tape Coating Line

Coating Machine - Process flow

 

Fifth, the common problems of coating and treatment methods:

6, pay attention to observe whether there are bubbles on the pole piece, exposed foil and other phenomena occur, once the shutdown occurs to adjust the left and right motor moving distance to deal with in time.
7. The initial roll diameter value of the unwinding is always set at 48% - 58%.
8. Open the test roll when the coating stops.
9. When the coating encounters a circle, click Reset.
10. The rewinding paper tube must be placed in the middle, and the winding is guaranteed to be neat. When marking the circle or other problems, mark it in time.
11. Check if the pole piece is dry when winding. If it is not dry, increase the temperature or reduce the speed.
12. The gap is not uniform. The coating tension can be changed by adjusting the lifting roller. The left and right motors can also be adjusted for fine adjustment.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com