Slitting Laminating Machine

Slitting Laminating Machine

Introduction to slitting machine:
     Slitting machine is a kind of mechanical equipment for slitting wide sheets of paper or film into a plurality of narrow-width materials, which are commonly used in papermaking machinery and printing and packaging machinery.
     The traditional control scheme of the slitter is to use a large motor to drive the shaft of the rewinding and unwinding. A magnetic powder clutch is added to the reel and reel, and the resistance generated by the magnetic clutch is controlled to control the tension of the surface of the material. . Magnetic powder clutches and brakes are special automatic actuators that transmit torque through the magnetic powder filled in the working gap. The magnetic current can be changed to change the magnetic state of the magnetic powder, and then the transmitted torque can be adjusted. It can be used for stepless speed regulation from zero to synchronous speed. It is suitable for high speed section fine adjustment and medium and small power speed control system. It is also used to adjust the torque by adjusting the current to ensure an unwinding or rewinding tension control system with a constant tension during winding.

Slitting Laminating Machine

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

Slitting Laminating Machine

Slitting machine instruction manual -

Second, the use of procedures;

6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com