Maintenance and maintenance of the slitter:
Before use, the main parts of the automatic slitting machine should be inspected and filled with lubricating oil. When inspecting the disassembly and assembly automatic slitting machine, it is strictly forbidden to use unsuitable tools and unscientific operation methods; every two weeks to the machine Make a comprehensive cleaning and inspection; if the automatic slitting machine is stopped for a long time, all the bright surfaces must be wiped clean, coated with anti-rust oil, and covered with a plastic sleeve to cover the whole machine. If the automatic slitting machine is deactivated for more than 3 months, the anti-rust oil should be covered with moisture-proof paper; after the work is completed, carefully clean the equipment, and wipe the exposed friction surface and add lubricant.
Tension information detection method
(1) Tension sensor detection method: It is a method of detecting the tension directly, closely combined with the machine, and without moving parts. Usually two sensors are paired and mounted on the end shafts on both sides of the detection guide roller.
(2) Roll diameter calculation type detection method: It uses the proximity switch installed at the reel to detect the rotation speed of the reel. Because the reel rotates once, the winding diameter will change twice the thickness of the material.
The current diameter of the reel is obtained by cumulative calculation by the initial value of the reel diameter and the material thickness, and the change of the corresponding reel diameter reflects the change of the actual tension value.
(3) Floating roller position detection mode: It uses the cylinder attached to the slitter to connect the floating roller to drive the angular displacement sensor to detect the tension change. When the tension is stable, the tension on the material is balanced with the cylinder force, so that the floating roller is in the center position. When the tension changes, the balance between the tension and the cylinder force is broken, and the position of the floating roller will rise or fall. At this time, the swing lever will rotate around a point and drive the floating roller angular displacement sensor to rotate together.
(4) Floating roller position + tension sensor combined tension detection mode: It can simultaneously detect the floating roller position signal output by the floating roller angular displacement sensor and the tension signal output by the tension sensor, thereby providing higher precision tension control to the system. .
Slitting machine instruction manual -
Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc