Small Tape Slitter

Small Tape Slitter

Preparation of slitter cutter
1. Razor slitting
1.1. The razor slitting requires the film to travel in the correct direction to the winding section.
1.2. Adjust the photoelectric tracking to bring the film to the proper position.
1.3. Tension the film and attach the blade to the razor holder.
1.4. According to the specifications required by the instruction sheet, the sliding razor holder is cut into the razor groove under the film, and the blade edge and the edge of the sipe are required to be in contact with each other.
1.5 After adjusting the depth of the cutter, lock the razor frame screws.
2. Round knife cutting
2.1. Check whether the upper and lower knives are sharp and have no gaps, and vice versa;
2.2. Determine the number of knives (N+1) according to the number of product series (N);
2.3. Install the lower knife to adjust the width of the lower knife according to the actual width of the product;
2.4 Install the upper knife correctly. The flat side of the upper knife is aligned with the side of the lower cutting edge. The upper knife is aligned with the gap between the lower knife and the septum. Press the screws on both sides to make the upper knife enter the gap depth to about 2mm. The upper knife is attached to the lower knife and fastened. Finally, the screw on the left side of the upper knife holder is adjusted so that the whole knife holder moves 1-2 mm to the right side and is fastened.

Small Tape Slitter

Slitting machine instruction manual -

Second, the use of procedures;

4. Check the position of the knife holder and the nozzle of the drum on the left side of the drum, and adjust the left and right distance of the blade so that the blade can be cut into the blade groove of the drum in the middle. The distance between the two blades is the length of the cutting nozzle: 20mm and 15mm. , tighten the screws on the blade holder to secure the blade position

Small Tape Slitter

Slitting machine operating procedures -

Third, through the film:
1. The cutter exits to the stop position. (The split knife switch is in the off position)
2. Press the “Pinch with chain” button and the hook and loop on the chain will run to the feeding position.
3. Press “Release Brake” until the indicator light is on, and the unwinder brake is released.
4. Pull one end of the film manually, pull the film along the running route to the film-piercing mechanism, and fix the film to the shackle of the chain.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com