1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;
Tape slitter starts up
1. Change the specification, the paper core is on the inner and outer winding arms, and the pressure roller is in the ready state to notify all personnel to leave the machine and prepare to run.
2. Put the ANTI-STAIC BARS on the main console into AUTO, READY TO RUN is turned on, and start MACHINE RUN to start up.
Tape cutting machine cutting control
During the slitting operation process, carefully observe and observe the effect of cutting and cutting, and appropriately adjust and control the slitting speed, unwinding tension, contact pressure, curved roller, edge pulling roller and leading edge.
Slitting machine instruction manual -
Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc