Roll Slitting Rewinder

Roll Slitting Rewinder

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Roll Slitting Rewinder

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

Roll Slitting Rewinder

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)
1. Press and hold the “winding side 1 swing” and “winding side 2 swing” buttons until the finished roll leaves the press roller (winding arm vertical state). 2. At the same time, the blades cut off the finished product on both sides, and the end of the film is glued to the finished roll as the end mark of the finished roll. 3. Continue to press and hold the “winding side 1 swing” and “winding side 2 swing” buttons, and the winding arm will open to both sides until the finished product rolls over to the unloading trolley tray and release the button.
4. Press the “Release side 1 card head release” and “Rewind side 2 card head release” buttons, the card head will open, release the finished product roll (if the finished product roll does not come down, manually shake the finished product roll).
5. Press and hold the “winding side 1 swinging” and “winding side 2 swinging” keys, and the winding arm station will be turned up and forward until the winding arm reaches the paper discharge core position and release the button.

6. Unload and unwind the trolley and advance the finished product to the packaging area.
7. After the winding arm is in the correct position, manually install the empty paper core (the double-sided adhesive should be attached to the paper core).

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com