Slitting Rewinder Machine

Slitting Rewinder Machine

Slitting adjustment
1. Put the cutter down, open the curling blower switch, set the winding tension, start the machine, run 2-3 meters, stop;
2. Measure the width of each joint to confirm whether the requirements are met. If there is any error, the ratio of the cutter should be re-matched.
3. Check whether each of the paper cores and the corresponding film are aligned, otherwise adjust them;

Slitting Rewinder Machine

Slitting machine instruction manual -

Second, the use of procedures;

6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.

Slitting Rewinder Machine

Slitting machine operating procedures -

First. When the unwinding machine normally replaces the parent roll
1. The machine is wound up and the machine speed is zero. Press the "machine off" button and all drives are turned off.
2. Press and hold the “core release” button to make the chuck exit the empty core, the empty core is placed on the unloading guide, and then the pneumatic ejector will automatically
Empty the core to the unloading position, release the button, and the steel core is to be transported away by the crane.
3. Press the “Coil Snap” button briefly to retract the cylinder rod at the unwinding position to the receiving position.
4. According to the plan, attach the corresponding mother roll to the double-sided tape, and hang the new mother roll into the V-shaped support that supports the parent roll, and hang the empty roll.
core.
5. Press and hold the “Coil Core Clamp” button to make the card head into the new parent roll until the card head positioning pin is in place and release the button. 6. Adjust the length and diameter of the unwinder on the operation screen (correct the input value if necessary), and replace the parent roll.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com