Opp Roll Slitting Machine

Opp Roll Slitting Machine

Slitting machine starts production
1. The winding roller is pressed down, the counter is cleared, and the production is started;
2. During the operation process, check the winding status of each joint from time to time, and adjust the tension according to the tightness of the winding to make each volume
The material is wound up and the end face is flush and firm;
3. Always pay attention to product quality during machine operation.
4. The machine has no abnormal sound.
5. Whether the photoelectric tracking operation is normal.
6. When checking the next volume, pay attention to check the surface of the product for quality defects and stick the tape as required.

Opp Roll Slitting Machine

Main factors affecting tension stability:
(1) The change of the speed of the machine will inevitably cause the change of the tension of the whole machine.
(2) During the process of collecting and unwinding, the winding and unwinding diameters of the slitting machine are constantly changing, and the change of the diameter will inevitably cause the change of the material tension. When the unwinding torque is constant, the diameter is reduced and the tension is increased. The winding is reversed. If the winding torque is constant, the tension will decrease as the winding diameter increases. This is the main factor that causes the change in material tension during operation.
(3) The change in the tightness of the raw material roll will also cause a change in the tension of the whole machine.
(4) The unevenness of the material of the raw material is cut. If the material elasticity fluctuates, the material thickness changes along the width and length direction, the mass of the material roll is eccentric, and the temperature and humidity of the production environment change, which also affects the tension fluctuation of the whole machine.
(5) The various transmission mechanisms (such as guide rollers, floating rollers, flattening rollers, etc.) of the slitting machine have factors such as imbalance and unstable air pressure.

Opp Roll Slitting Machine

Slitting machine instruction manual -

Second, the use of procedures;

6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com