Daily maintenance and maintenance of the slitter:
First, the electrical parts should be cleaned and inspected regularly to remove hidden dangers in time.
Second, the use of slitting machines is done by slitting machines and cross-cutting machines. Therefore, high-quality slitting cutters and cross-cutting cutters are used.
Third, the daily maintenance of the slitting machine should be in place. The standard is that smooth, clean, clear (no dust, no debris) is in place to ensure that the sliding part of the equipment is in good condition.
Fourth, it is the maintenance work, and the regular and irregular inspections of the rotating parts should be stopped (especially the real-time monitoring of the wearing parts should be stopped). Regular adjustments are made, regular changes are made, commutators are carefully recorded, and the purpose of extending the service life of the equipment is achieved.
Fifth, improve the technical quality and degree of the personnel who operate the slitting machine. The control of the local operation must be done by a special person, and no one can operate it without any permission.
Tape slitter starts up
1. Change the specification, the paper core is on the inner and outer winding arms, and the pressure roller is in the ready state to notify all personnel to leave the machine and prepare to run.
2. Put the ANTI-STAIC BARS on the main console into AUTO, READY TO RUN is turned on, and start MACHINE RUN to start up.
Tape cutting machine cutting control
During the slitting operation process, carefully observe and observe the effect of cutting and cutting, and appropriately adjust and control the slitting speed, unwinding tension, contact pressure, curved roller, edge pulling roller and leading edge.
Slitting machine instruction manual -
Second, the use of procedures;
5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc