Daily maintenance and maintenance of the slitter:
First, the electrical parts should be cleaned and inspected regularly to remove hidden dangers in time.
Second, the use of slitting machines is done by slitting machines and cross-cutting machines. Therefore, high-quality slitting cutters and cross-cutting cutters are used.
Third, the daily maintenance of the slitting machine should be in place. The standard is that smooth, clean, clear (no dust, no debris) is in place to ensure that the sliding part of the equipment is in good condition.
Fourth, it is the maintenance work, and the regular and irregular inspections of the rotating parts should be stopped (especially the real-time monitoring of the wearing parts should be stopped). Regular adjustments are made, regular changes are made, commutators are carefully recorded, and the purpose of extending the service life of the equipment is achieved.
Fifth, improve the technical quality and degree of the personnel who operate the slitting machine. The control of the local operation must be done by a special person, and no one can operate it without any permission.
Tape cutting machine receipt：
1. When the inner and outer ends of the machine are stopped, use the unloading button to place the film on the prepared unloading trolley, cut the film and paste the film roll with the sealing glue.
2. Use the collet release button to release the chuck and check whether the film cores have left the core. If one is still stuck on the core, manually remove the film roll manually.
3. After ensuring that all the film leaves the chuck on the trolley, use the film button to raise the winding arm, install the corresponding paper core, and attach the film to the paper core for the next slitting.
Slitting machine instruction manual -
Second, the use of procedures;
6. The gears inside the tool holder are regularly cleaned and greased.
7. When moving the tool holder, remove the upper and lower screws and translate it to the left to release the blade from the blade groove of the drum. Then release the timing belt and pull out the timing pulley on the tool holder shaft to remove the whole. Tool holder for maintenance and cleaning.
During installation, the tool holder translates against the drum, so that the blade is correctly cut into the drum groove, fix the upper and lower screws, install the timing pulley from the back, and loosen the foot screw of the drive motor to the right to facilitate the synchronization. With the belt, then the motor base moves to the right, confirming the proper tightness of the timing belt, and fixing the motor base screw to work normally.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc