Small Slitter Machine

Small Slitter Machine

Daily maintenance and maintenance of the slitter:
First, the electrical parts should be cleaned and inspected regularly to remove hidden dangers in time.
Second, the use of slitting machines is done by slitting machines and cross-cutting machines. Therefore, high-quality slitting cutters and cross-cutting cutters are used.
   Third, the daily maintenance of the slitting machine should be in place. The standard is that smooth, clean, clear (no dust, no debris) is in place to ensure that the sliding part of the equipment is in good condition.
Fourth, it is the maintenance work, and the regular and irregular inspections of the rotating parts should be stopped (especially the real-time monitoring of the wearing parts should be stopped). Regular adjustments are made, regular changes are made, commutators are carefully recorded, and the purpose of extending the service life of the equipment is achieved.
Fifth, improve the technical quality and degree of the personnel who operate the slitting machine. The control of the local operation must be done by a special person, and no one can operate it without any permission.

Small Slitter Machine

Slitting machine instruction manual -

Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.

Small Slitter Machine

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)
1. Press and hold the “winding side 1 swing” and “winding side 2 swing” buttons until the finished roll leaves the press roller (winding arm vertical state). 2. At the same time, the blades cut off the finished product on both sides, and the end of the film is glued to the finished roll as the end mark of the finished roll. 3. Continue to press and hold the “winding side 1 swing” and “winding side 2 swing” buttons, and the winding arm will open to both sides until the finished product rolls over to the unloading trolley tray and release the button.
4. Press the “Release side 1 card head release” and “Rewind side 2 card head release” buttons, the card head will open, release the finished product roll (if the finished product roll does not come down, manually shake the finished product roll).
5. Press and hold the “winding side 1 swinging” and “winding side 2 swinging” keys, and the winding arm station will be turned up and forward until the winding arm reaches the paper discharge core position and release the button.

6. Unload and unwind the trolley and advance the finished product to the packaging area.
7. After the winding arm is in the correct position, manually install the empty paper core (the double-sided adhesive should be attached to the paper core).

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com