Tape slitting machine technical parameters
One: Introduction to tape slitting machine
The slitting machine mainly divides the large-rolled master roll into products of different widths and can check the quality of the product. Its main features are as follows:
1. Unwinding photoelectric correction, high precision; divided into two files: manual and automatic
2, there can be two ways of winding: surface winding and center winding;
3. The unwinding tension adopts automatic tension;
4, round knife cutting, reliable quality, easy to adjust;
5, using the surface center winding, the winding quality is even and stable;
6, the fixed length automatically stops, the length automatically counts the meter;
7, has a trimming device, the edge material is discharged by the fan;
8. Particularly suitable for slitting of narrow strips (insulating materials, mica tapes, films, etc.)
Slitting machine instruction manual -
Second, the use of procedures;
1. Check whether the parts of the machine are loose due to transportation and other reasons, adjust the four foot screws of the machine, and verify that the machine is level on the ground.
2. External high-pressure gas is supplied to the pressure regulating valve. The purpose of the second air pipe blowing is to eliminate the residual nozzle in the empty groove at the lower right of the drum, so that the drum can smoothly accept the new nozzle and adjust the pressure of the pressure regulating valve. The best use.
Slitting machine operating procedures -
First. When the unwinding machine normally replaces the parent roll
1. The machine is wound up and the machine speed is zero. Press the "machine off" button and all drives are turned off.
2. Press and hold the “core release” button to make the chuck exit the empty core, the empty core is placed on the unloading guide, and then the pneumatic ejector will automatically
Empty the core to the unloading position, release the button, and the steel core is to be transported away by the crane.
3. Press the “Coil Snap” button briefly to retract the cylinder rod at the unwinding position to the receiving position.
4. According to the plan, attach the corresponding mother roll to the double-sided tape, and hang the new mother roll into the V-shaped support that supports the parent roll, and hang the empty roll.
5. Press and hold the “Coil Core Clamp” button to make the card head into the new parent roll until the card head positioning pin is in place and release the button. 6. Adjust the length and diameter of the unwinder on the operation screen (correct the input value if necessary), and replace the parent roll.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc