Tape slitting machine principle：
1. The paper slitting machine shall carry out the fixed length slitting processing of the whole roll or the whole raw material, such as plastic packaging materials, packaging carton, steel plate, film, leather, wood chip, etc., and the fixed length slitting control shall be used.
2. The slitting length can be set continuously. If there is an error in the actual slitting length, it is easy to calibrate by setting parameters.
3. The slitting control of the paper slitter is divided into static and dynamic slitting: it stops accurately when the set length arrives, then static slitting processing, restarts after slitting; when the set length arrives, it does not stop. The slitting signal is dynamically slitted during the material movement process.
Tape slitter starts up
1. Change the specification, the paper core is on the inner and outer winding arms, and the pressure roller is in the ready state to notify all personnel to leave the machine and prepare to run.
2. Put the ANTI-STAIC BARS on the main console into AUTO, READY TO RUN is turned on, and start MACHINE RUN to start up.
Tape cutting machine cutting control
During the slitting operation process, carefully observe and observe the effect of cutting and cutting, and appropriately adjust and control the slitting speed, unwinding tension, contact pressure, curved roller, edge pulling roller and leading edge.
Slitting machine operating procedures -
Second, the volume of the replacement of the finished product (operating station)
1. Press and hold the “winding side 1 swing” and “winding side 2 swing” buttons until the finished roll leaves the press roller (winding arm vertical state). 2. At the same time, the blades cut off the finished product on both sides, and the end of the film is glued to the finished roll as the end mark of the finished roll. 3. Continue to press and hold the “winding side 1 swing” and “winding side 2 swing” buttons, and the winding arm will open to both sides until the finished product rolls over to the unloading trolley tray and release the button.
4. Press the “Release side 1 card head release” and “Rewind side 2 card head release” buttons, the card head will open, release the finished product roll (if the finished product roll does not come down, manually shake the finished product roll).
5. Press and hold the “winding side 1 swinging” and “winding side 2 swinging” keys, and the winding arm station will be turned up and forward until the winding arm reaches the paper discharge core position and release the button.
6. Unload and unwind the trolley and advance the finished product to the packaging area.
7. After the winding arm is in the correct position, manually install the empty paper core (the double-sided adhesive should be attached to the paper core).
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc