Tape slitting machine principle：
1. The paper slitting machine shall carry out the fixed length slitting processing of the whole roll or the whole raw material, such as plastic packaging materials, packaging carton, steel plate, film, leather, wood chip, etc., and the fixed length slitting control shall be used.
2. The slitting length can be set continuously. If there is an error in the actual slitting length, it is easy to calibrate by setting parameters.
3. The slitting control of the paper slitter is divided into static and dynamic slitting: it stops accurately when the set length arrives, then static slitting processing, restarts after slitting; when the set length arrives, it does not stop. The slitting signal is dynamically slitted during the material movement process.
Tension information detection method
(1) Tension sensor detection method: It is a method of detecting the tension directly, closely combined with the machine, and without moving parts. Usually two sensors are paired and mounted on the end shafts on both sides of the detection guide roller.
(2) Roll diameter calculation type detection method: It uses the proximity switch installed at the reel to detect the rotation speed of the reel. Because the reel rotates once, the winding diameter will change twice the thickness of the material.
The current diameter of the reel is obtained by cumulative calculation by the initial value of the reel diameter and the material thickness, and the change of the corresponding reel diameter reflects the change of the actual tension value.
(3) Floating roller position detection mode: It uses the cylinder attached to the slitter to connect the floating roller to drive the angular displacement sensor to detect the tension change. When the tension is stable, the tension on the material is balanced with the cylinder force, so that the floating roller is in the center position. When the tension changes, the balance between the tension and the cylinder force is broken, and the position of the floating roller will rise or fall. At this time, the swing lever will rotate around a point and drive the floating roller angular displacement sensor to rotate together.
(4) Floating roller position + tension sensor combined tension detection mode: It can simultaneously detect the floating roller position signal output by the floating roller angular displacement sensor and the tension signal output by the tension sensor, thereby providing higher precision tension control to the system. .
Slitting machine instruction manual -
Second, the use of procedures;
4. Check the position of the knife holder and the nozzle of the drum on the left side of the drum, and adjust the left and right distance of the blade so that the blade can be cut into the blade groove of the drum in the middle. The distance between the two blades is the length of the cutting nozzle: 20mm and 15mm. , tighten the screws on the blade holder to secure the blade position
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc