Sletting Machine

Sletting Machine

Tape slitter setting control:
1. Set the slitting menu according to the type, thickness, length, width, etc. of the film arranged in the slitting plan.
2. Lift the corresponding BOPP film file from the PDF.
3. Set the winding length and width of the film of the corresponding specification.
4. Select the corresponding winding station, adjust the pressure roller arm and pressure roller, and install the paper core of the corresponding specifications.

Sletting Machine

Main factors affecting tension stability:
(1) The change of the speed of the machine will inevitably cause the change of the tension of the whole machine.
(2) During the process of collecting and unwinding, the winding and unwinding diameters of the slitting machine are constantly changing, and the change of the diameter will inevitably cause the change of the material tension. When the unwinding torque is constant, the diameter is reduced and the tension is increased. The winding is reversed. If the winding torque is constant, the tension will decrease as the winding diameter increases. This is the main factor that causes the change in material tension during operation.
(3) The change in the tightness of the raw material roll will also cause a change in the tension of the whole machine.
(4) The unevenness of the material of the raw material is cut. If the material elasticity fluctuates, the material thickness changes along the width and length direction, the mass of the material roll is eccentric, and the temperature and humidity of the production environment change, which also affects the tension fluctuation of the whole machine.
(5) The various transmission mechanisms (such as guide rollers, floating rollers, flattening rollers, etc.) of the slitting machine have factors such as imbalance and unstable air pressure.

Sletting Machine

Slitting machine operating procedures -

Second, the volume of the replacement of the finished product (operating station)
1. Press and hold the “winding side 1 swing” and “winding side 2 swing” buttons until the finished roll leaves the press roller (winding arm vertical state). 2. At the same time, the blades cut off the finished product on both sides, and the end of the film is glued to the finished roll as the end mark of the finished roll. 3. Continue to press and hold the “winding side 1 swing” and “winding side 2 swing” buttons, and the winding arm will open to both sides until the finished product rolls over to the unloading trolley tray and release the button.
4. Press the “Release side 1 card head release” and “Rewind side 2 card head release” buttons, the card head will open, release the finished product roll (if the finished product roll does not come down, manually shake the finished product roll).
5. Press and hold the “winding side 1 swinging” and “winding side 2 swinging” keys, and the winding arm station will be turned up and forward until the winding arm reaches the paper discharge core position and release the button.

6. Unload and unwind the trolley and advance the finished product to the packaging area.
7. After the winding arm is in the correct position, manually install the empty paper core (the double-sided adhesive should be attached to the paper core).

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com