1300 Slitting Rewinding Machine

1300 Slitting Rewinding Machine

Tape slitting machine feeding, filming and filming
1. Loading: According to the requirements of the cutting plan, according to the driving operation rules, according to the actual situation, hoist the corresponding mother roll on the aging frame, place it on the unwinding unwinding frame according to the inner and outer selection direction of the corona surface, and use the control button Clamp the steel core, leave the steel core support arm and drive.
2. Film penetration: When there is no film on the slitter, the film must be penetrated. Using the slitting machine through the membrane device and the function keys, one end of the original membrane is attached to the membrane chain eyelet, and the membrane button is activated to distribute the membrane along the slitting process to be evenly distributed on each roller.
3. Film: When there is a film on the slitter, when changing the joint, use the vacuum filming table to start the filming station to the working position, manually flatten the film on the first pulling roller of the slitting machine and start the upper vacuum pumping film. Soak the film flat on the filming table, attach the double-sided tape and cut off the excess film under the tape, flatten the film on the unwinding frame and start the lower vacuum pump to make the film flat and absorb the paper. Layer and flatten the adhesive film, the joints should be neat and wrinkle-free, then turn off the upper and lower vacuum pumps to open the filming station to the inoperative position.

1300 Slitting Rewinding Machine

Main way of tension control
The tension control method is generally divided into two types: open loop control mode and closed loop control mode. The open loop control is to directly drive the winding mechanism with an electric motor having a similar winding characteristic n = kD (n is the rotational speed, k is a constant, and D is the diameter of the winding roller) to obtain an approximate constant tension operation. The open loop control has poor randomness and low control precision. The closed loop tension control has two kinds of direct tension control and indirect tension control. In the actual production process, the volume is adjusted, that is, the tension is fed back, compared with the given tension, and then the difference is applied to the regulator to adjust the controlled object so that the output tension meets the actual demand. It is called direct tension closed-loop control. This method can eliminate the steady-state error without considering various compensations. The indirect tension control uses the motor speed-torque characteristic curve to control the torque to control the torque, so as to achieve the purpose of controlling the tension. This method requires dynamic and static compensation. Sometimes, in order to obtain more precise control performance, a composite tension control method is adopted, that is, the required control amount is first determined according to an indirect control algorithm, and various compensations are considered to make the indirect control as accurate as possible, and then the direct tension control is used for fine adjustment.

1300 Slitting Rewinding Machine

Slitting machine instruction manual -

Second, the use of procedures;

5. After filling the nozzle, turn on the key switch power, the green light is on, pay attention to the following operations:
A. Always press the knife green button first to make the blade rotate first, and check if the rotation is smooth and there is no harsh sound.
B. Press the Drum green button again to make the drum rotate, and confirm that the small shaft in the upper right corner of the drum starts to rotate, and then start working.
C. If there is a fault and need to stop, always confirm: first press the Drum red stop button, stop for 1-2 seconds and then press the Knfe red button to stop the blade, so as to avoid the stick stick between the drum and the blade.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com