Adhesive Tape Rolling Machine

Adhesive Tape Rolling Machine

Rewinding Machine operating procedures - Unwinding paper core
(1.) Post operator
1. First check the cutting distance of the measuring cutter, which is consistent with the specifications required by the process standard.
2. Before placing the paper core, first check whether the paper core used meets the requirements for use:
A. Is the size of the specification the same as the roll paper size?
B. Is the inner diameter and outer diameter of the paper core acceptable (the thickness is consistent).
C. Does the strength of the paper core meet the requirements?
D. Whether the port is layered or burred.
E. Can be put on the machine after passing the inspection and passing the test.
3. Signal the main operation: Start the ejector pin pump button and insert the paper core onto the ejector cone.
4. Shake the two thimble handles to the left to push the core.
5. Align the edge of the paper core port (the difference between left and right cannot exceed one millimeter).

(2) Main operation
1. Review again whether the paper cores on the board meet the requirements.
2. Review whether the thimble is inserted into the lock (avoid the end of the paper roll is not aligned)
3. Check the sharpness of the upper and lower round knives, the depth of the occlusion and the angle to ensure the quality of the trimming.

Adhesive Tape Rolling Machine

Rewinding Machine safety operation guide - 

Second, the rewinding machine is opened and shut down:
1. Check the equipment thoroughly before starting the machine to check whether the round knife and the bottom knife are in good condition.
2. Whether the size of the round knife meets the requirements of finished products and cutting specifications
3. Hang the rewinding paper roller on the paper feeding frame, and make the brake and roller contact with each other.
Whether the fuse cover on both sides of the core and the barrel of the core is covered.

Adhesive Tape Rolling Machine

Rewinding Machine safety operation guide - 

Sixth, change the specification operation:
1. Stop the winder and lift the round knife and tighten the bolts on the base of the round knife.
2. Move the base of the circular knife holder and measure the distance between two adjacent circular cutters with a tape measure to make it conform to
Paper specification requirements.
3. Fix the base of the round knife holder, tighten the bolts, and measure the specifications once again.
Dynamic rewinding (contact angle, tightness, depth).

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com