Rewinding Machine operating procedures - Unwinding paper core
(1.) Post operator
1. First check the cutting distance of the measuring cutter, which is consistent with the specifications required by the process standard.
2. Before placing the paper core, first check whether the paper core used meets the requirements for use:
A. Is the size of the specification the same as the roll paper size?
B. Is the inner diameter and outer diameter of the paper core acceptable (the thickness is consistent).
C. Does the strength of the paper core meet the requirements?
D. Whether the port is layered or burred.
E. Can be put on the machine after passing the inspection and passing the test.
3. Signal the main operation: Start the ejector pin pump button and insert the paper core onto the ejector cone.
4. Shake the two thimble handles to the left to push the core.
5. Align the edge of the paper core port (the difference between left and right cannot exceed one millimeter).
(2) Main operation
1. Review again whether the paper cores on the board meet the requirements.
2. Review whether the thimble is inserted into the lock (avoid the end of the paper roll is not aligned)
3. Check the sharpness of the upper and lower round knives, the depth of the occlusion and the angle to ensure the quality of the trimming.
Rewinding Machine safety operation guide -
Seventh, production operations and quality control during the rewinding process:
4, pay attention to the quality of the rewinding of the paper roll when rewinding, found zigzag, knife, running,
If the color difference is serious, skipping, chain printing, wrinkling, violent edge, etc., the result should be stopped in time. Only after the inspector confirms can the machine be re-rolled.
5. When the rewinding operation is running, the host must be at the console, and must not leave at will to prevent accidents. Transport
The speed of lifting and lowering is slow, and the speed of the vehicle cannot exceed the prescribed limit.
6. When loading the paper core tube, it is necessary to select the paper core with the same outer diameter and the length specification in line with the quality standard.
The installation of the cylinder requires a large deviation of the outer diameter and needs to be replaced.
Rewinding Machine operating procedures -
Two: shutdown process:
1. Click the “Stop Detection” button and use the ICW program “Shutdown”;
2. Turn off the detection system switch;
3. Turn off the total power switch of the winder;
4. Close the total air valve.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc