Tape Cutting Machine-
First, the precautions before installation and installation:
1. Install the equipment in a dry, clean and well ventilated place.
2. The equipment should be protected and connected to zero, that is, the casing part is connected with the neutral line in the three-phase four-wire (the product with the power plug is connected to the factory).
3. The power supply in the workplace should be normal, without excessive fluctuations, otherwise the equipment cannot guarantee normal operation.
4. Steps for equipment installation:
a. The power incoming line is connected to the user-supplied three-phase switch of suitable capacity. The three-phase switch shall be fitted with a fuse that meets the requirements and shall not be arbitrarily amplified. The three-phase switch should be dedicated to the cutting machine.
b. The gas source is connected to the inlet end of the filter pressure reducing valve on the rear plate of the cutting chassis through the gas supply pipe, that is, facing the left side joint of the pressure gauge.
c. Clamp the working ground clamp of the cutting machine (the positive output end of the cutting power supply) on the workpiece.
What are the specifications of Guolian cutting machine?
The automatic hydraulic cutting machine works by pressing down the mold and cutting the material through the mold/mold.
Suitable for die cutting all non-metallic soft/semi-soft materials. From manual to fully automatic, suitable for leather, fabric, EVA / EPE foam, blister packaging, rubber, sponge, car / aircraft.
Fully meet the requirements of providing professional cutting solutions / feeding systems.
Tape Cutting Machine - related instructions
The tape cutting machine is also a tape machine, which is an indispensable small auxiliary mechanical device for most production lines, but there is no specific explanation for the technical operation. The following is a description based on the operation of the tape cutting machine. The operation of the tape cutter is different from that of the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut, if cut. If the tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc