Auto Cutting Machine

Auto Cutting Machine

Tape Cutting Machine-

Third, pay attention to the operation process:
1. The torch is in contact with the workpiece and can be cut by pressing the button. Cutting can be started from the edge of the workpiece. When the thickness of the sheet is not large, it can be cut at any point of the workpiece. The torch can be perpendicular to the workpiece
Or slightly inclined to one side, but when opening in the middle of the workpiece, the torch should be tilted slightly to one side in order to blow off the molten metal and cut through the metal.
2. Press the handle button and keep the main circuit on, while the high frequency oscillator works until the cutting arc is formed, and the high frequency oscillator stops working. Thereafter, the cutting can be performed by the movement of the torch. At the same time, the cutting indicator lights.
3. The cutting must be cut through the metal to move evenly, otherwise the nozzle will be damaged. Moving too fast or too slow will affect the quality of the cut.
4, cutting air pressure adjustment: cutting air pressure is too high, the flow is too large, will affect the cutting thickness. If the cutting air pressure is too small, it will affect the service life of the nozzle.
5. Before lifting the torch away from the workpiece, the handle button must be turned on. At this time, the plasma arc is extinguished and the cutting process is stopped.
6. During the cutting process, the arc is re-arced because the torch leaves the workpiece more than 2 mm and the arc is extinguished.
7. When the main transformer temperature exceeds 110 °C due to the connection working time is too long, the thermal protection switch will operate and the device will automatically shut down and cannot be started. It should be restarted after the transformer has cooled down.
8. Always remove the accumulated water in the filter pressure reducing valve, that is, rotate the lowermost screw counterclockwise to remove the water and then tighten. If there is too much water in the compressed air, consider adding a filter valve between the filter pressure reducing valve and the gas source, otherwise the cutting quality will be affected.
9. When the workpiece is not cut, press the torch button as little as possible to avoid damage to the machine.
10. After the cutting workpiece is finished, cut off the power switch and the air supply valve.

Auto Cutting Machine

The relationship between the tape cutting machine and the tape -


1: What is tape? It refers to a tape film that can be attached and adhered in a certain way, such as pressing, heating, etc., called tape. There is no certain standard for the quality of the tape. Any tape that meets the customer's needs is not only a good tape, but also a tape cutter that satisfies the customer's needs.

Auto Cutting Machine

The relationship between the tape cutting machine and the tape -

2: The tape mainly includes single-sided tape, double-sided tape, industrial tape, electronic tape, medical tape, acrylic tape, rubber tape, and silicone tape. The main substrate of the tape is paper, cloth, film, etc.; the support of the tape cutter is mainly a release paper, a release film, etc.; the adhesive has an acrylic adhesive, and a rubber adhesive. Substrate and support physical property testing focuses on basis weight, thickness, elongation, and release force; the focus of adhesive property testing is viscosity solid content. The physical properties of the tape are measured by coating amount, coating thickness, adhesion, holding power, adhesion from the back surface, drawing force, initial adhesion, weather resistance, heat resistance, solvent resistance, electrical conductivity, flame resistance, and the like.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com