Tape Cutting Machine features:
1. The tape cutting machine adopts no roller design, which is convenient for operation.
2, the maximum width of the cutting is 60mm (see machine parameters below), this must be understood before use, to see if it meets the width of the tape you want to cut.
3, the tape cutting machine with memory function, according to the length of the tape cut usually from the set of six different cutting lengths, you can call directly after the need to set up.
4, install the tape, through the elastic film auxiliary shaft, so it is easier to fix the film to prevent the tape roll from falling.
5, tape cutting machine with counting function, you can set the amount to be cut.
6. Two rolls of tape can be used at the same time, but the total width should be within the width parameter of the tape cutter.
7. Be careful when taking the tape. Although the tape cutter is equipped with a protective device and a safety guard at the knife edge, try not to approach the knife edge.
8, accurate digital control cutting length, you can set the length you want to cut.
9. It is not necessary to adjust the tape cutter because of the thickness of the tape.
10. The tape cutting machine has built-in pliers, lubricating oil and partition for easy operation.
11, anti-static ABS material
Guolian Machinery -- GL-5000 Tape Cutting Machine
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.
Cutting length: 5 ~ 999 mm
Tape width: 6 ~ 50 mm
Maximum outer diameter: 300 mm
Speed: 200 mm/min
Weight: 2.8 kg
Size: 115mm X 140mm X 215mm
GL-5000 tape cutter to cut two kinds of tape at the same time steps and precautions
If the tape width is less than 10 mm, insert the divider. This model can cut two tapes with a width of less than 25 mm at the same time.
1. Remove the divider from the bottom of the machine.
2. Press the press cover button to open the press cover.
3. If the tape width is less than 10 mm, insert the auxiliary spacer.
! Remove the auxiliary divider from the bottom of the machine and insert it into the junction of the divider.
4. Install the tape roll and move the width bar to adjust the tightness of the guide plate.
5. Import the tape and set the working mode.
! In the automatic mode, when cutting two sets of tape, take two pieces of tape and the machine will cut the two pieces of tape.
1. Forcibly cutting high-adhesive tape will affect the service life of the motor.
2. After using the divider and auxiliary dividers, return to the bottom of the machine.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc