Pizza Machine

Pizza Machine

Instructions for the operation of the tape cutter.
The tape cutter is operated differently than the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut.
If the cut tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be put into the tape cutting machine, the tape head should be pulled, then the power is turned on, and the switch is turned on.
Set according to the requirements, press the yellow button (start button) on the right after setting, the tape cutting machine starts to run and cut. The tape cutter cuts only a piece of tape at a time, and spits the cut tape out at the gate.
The sensor is installed at the gate. If the tape is not removed, the tape cutter will remain in a stagnant state. When we remove the tape, the tape cutter will automatically start and cut the next tape. Cycle back and forth.

Pizza Machine

Semi-automatic cutting machine technical operation rules

4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.

Pizza Machine

Tape cutting machine --- function
According to the application range of the tape cutter, the general tape cutter has the following functions: it can cut different materials such as tape, adhesive tape and protective film. You can simultaneously clamp two rolls of tape while cutting. Memory function, turn it off and then turn it on, and still save the original data. Cyclic cutting function, free to set different lengths of cyclic cutting, can cut different thickness of adhesive tape. The safety performance is high. The safety baffle is designed at the cutter. When the machine is blocked, the alarm device works automatically. Even if the blockage is cleared, the machine will not work immediately. You must press the start button again to continue working. Tape cutters are usually designed with no rollers.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com