Instructions for the operation of the tape cutter.
The tape cutter is operated differently than the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut.
If the cut tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be put into the tape cutting machine, the tape head should be pulled, then the power is turned on, and the switch is turned on.
Set according to the requirements, press the yellow button (start button) on the right after setting, the tape cutting machine starts to run and cut. The tape cutter cuts only a piece of tape at a time, and spits the cut tape out at the gate.
The sensor is installed at the gate. If the tape is not removed, the tape cutter will remain in a stagnant state. When we remove the tape, the tape cutter will automatically start and cut the next tape. Cycle back and forth.
Film /Paper/ fabric roll cut tape slitting machine is used for slitting or cutting various widths of materials into a small tape roll.
It is suitable for slitting or cutting: cloth, non-woven fabric, tent, umbrella, sponge foam, leather, reflective material, plastic, paper, double side adhesive tape, acetate various fabric, reinforced tape, electric conductive fabric, copper foil and etc.
and the tape slitting process is like this:
A roll of fabric, film or paper is loaded onto the axis, the machine will roll cut or slit this fabric roll ( film roll or paper roll ) into a small tape roll in designate width.
for packaging food:
large rolls of plastic film such as biaxially orientated polypropylene (BOPP), paper or adhsive tape is produced in large diameter roll for maxium efficiency.
the roll are then slit by a tape slitting machine into small rolls of the size to used on the packaging machine.
for Apparel and home use products:
large rolls of fabric or cloth can be slit into various width tape to used as the piping or decoration on the apparel.
and the slitted tape can also be used as the raw material for tape edging the mattress, or for mattress border decoration.
Automatic double sided adhesive tape cutting machine:
This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.
Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.
You can cut different sizes according to different material.
7. Round knife Angle adjustment system ( optional): The Mitsubishi servo motor control to calculate the circular knife Angle.According to different materials to do different angles change (adjustment range: + / -8 ° ) .If the cutting surface is not good, you can change the cutting Angle according.That will increase the production efficiency.
8. Automatic roll changing system (optional): The cylinder drive positioning gear to drive the active spline.Make sure the fast and accurate change of log roll but without stopping during cutting,
Save the loading and unloading time and increase the productivity.
9.Fast cutting shaft changing system (optional): 3 different size cutting shafts for optional.
You can cutting different size paper core log roll in the fast shaft changing device.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc