Mini Lathe Machine

Mini Lathe Machine

The tape cutting process of the Guolian tape slitter is like this:

A roll of fabric, film or paper is loaded onto the shaft and the machine will roll or cut the fabric roll (film roll or roll) into small rolls of specified width.
Industry use:

For packaging food:

Large rolls of plastic film, such as biaxially oriented polypropylene (BOPP), paper or adhesive tape, are produced in large diameter rolls for maximum efficiency.

The tape is then cut into small rolls suitable for use in the packaging machine using a tape slitter.

Suitable for clothing and household items:

Large rolls of fabric or fabric can be cut into tape of various widths for use as a conduit or decoration on the garment.

And the slit tape can also be used as a raw material for the edge of the belt of the mattress or the decoration of the mattress frame.

Mini Lathe Machine

Semi-automatic cutting machine technical operation rules

4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.

Mini Lathe Machine

GL-5000 tape cutter to cut two kinds of tape at the same time steps and precautions
If the tape width is less than 10 mm, insert the divider. This model can cut two tapes with a width of less than 25 mm at the same time.
1. Remove the divider from the bottom of the machine.
2. Press the press cover button to open the press cover.
3. If the tape width is less than 10 mm, insert the auxiliary spacer.
! Remove the auxiliary divider from the bottom of the machine and insert it into the junction of the divider.
4. Install the tape roll and move the width bar to adjust the tightness of the guide plate.
5. Import the tape and set the working mode.
! In the automatic mode, when cutting two sets of tape, take two pieces of tape and the machine will cut the two pieces of tape.
*note
1. Forcibly cutting high-adhesive tape will affect the service life of the motor.
2. After using the divider and auxiliary dividers, return to the bottom of the machine.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com