The main features of the National Union cutting machine
◎ Centralized control of all buttons, easy to operate.
◎The unwinding wheel adopts an arch design to wipe off the wrinkles of the tape during the feeding process.
◎ Equipped with industrial blade (air knife), suitable for slitting of BOPP tape.
◎The winding of the remaining material can be oscillated, which reduces the time for the remaining material to change the apron and improves the efficiency.
◎The oil pressure feeding mechanism can feed quickly and reduce labor intensity. (optional)
◎Automatic labeling mechanism to improve economy. (optional)
◎The feeding mechanism is equipped with a partition cover to reduce the material discharge noise and achieve the ideal working condition. (optional)
Automatic tape cutting machine tape machine - Detailed introduction
1: Press the switch button to cut the adhesive tape, half a turn around the turntable.
2: The cutting distance is adjustable.
3: The unique conveyor system makes it easier to pick up than the edge of the turntable.
4: Small adhesive tape for use on the board.
5: The emission interval can be adjusted according to the bandwidth.
6: Various adhesive tapes can be cut and the incision is sharp.
7: Using a dedicated base, the outer diameter of the tape can reach 170mm
Cutting size 13-60mm
Tape width 3-25mm
Size: 300w*165h-170d MM;
Cutting size: 13-60MM;
Tape width: 3-25MM;
Reel size: inner diameter 25-32-75MM, outer diameter: Up to 130mm;
Applicable tape: vinyl tape, polyester film tape, polyethylene tape, acetate base tape, cellophane, masking tape, plain paper, glass cloth tape, aluminum foil tape, cotton tape, double-sided tape, etc.;
Power requirements: AC100V, 120V, 220±20VM 50-60HZ, 160W;
Semi-automatic cutting machine technical operation rules
4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc