What are the specifications of Guolian cutting machine?
The automatic hydraulic cutting machine works by pressing down the mold and cutting the material through the mold/mold.
Suitable for die cutting all non-metallic soft/semi-soft materials. From manual to fully automatic, suitable for leather, fabric, EVA / EPE foam, blister packaging, rubber, sponge, car / aircraft.
Fully meet the requirements of providing professional cutting solutions / feeding systems.
The difference between the scope and model of the tape cutting machine -
Adhesive paper cutting machine CELL-1000
If you forget to install the tape with automatic reminder function, and with the counting function, the set data will automatically stop at the end, remind the music to sound, and automatically light up. There may be a variety of tapes on the market.
Tape width: 7mm-50mm
Tape length setting range: 20mm-999mm Maximum tape outer diameter: 170mm
Power: AC100V 117V 230V can be corresponding
Semi-automatic cutting machine technical operation rules
4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc