Tape Cutting Machine - related instructions
The tape cutting machine is also a tape machine, which is an indispensable small auxiliary mechanical device for most production lines, but there is no specific explanation for the technical operation. The following is a description based on the operation of the tape cutting machine. The operation of the tape cutter is different from that of the disc tape cutter, because they are different tape cutter models, and the shape is also very different. This tape cutter is ready to cut, if cut. If the tape is not removed in time, the tape cutter will stop cutting until the cut tape is removed, which is more flexible.
The tape cutter has a large knife edge, so you can cut all the tapes within the width range, and you can cut two tapes with a small width at the same time (the width is added to the tape cutter parameters).
The difference between the scope and model of the tape cutting machine -
Non-stick wheel type tape machine TDA080-NS
Configure specially processed rollers that are not easily attached to the rollers.
Suitable for foam tape, double-sided tape (double-sided tape without bottom paper can also be used). Specialized heavy duty cutting machine for industrial use. Suitable for work of more than 8 hours a day.
The automatic transfer cutting function can be used for structural lengths greater than 70 mm. For special models, please test the tape before purchasing. Designed on the basis of TDA080.
Specifications: Tape width: 13-80mm
Tape length setting range: 40-9999mm Maximum tape outer diameter: 230mm
Power supply: AC 100V 50/60Hz (117V, 230V is also available)
Semi-automatic cutting machine technical operation rules
4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc