Laser Cutting Machine Price

Laser Cutting Machine Price

Tape Cutting Machine - related instructions

         The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
         The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.

Laser Cutting Machine Price

GL-704B tape cutting machine product specifications:

 
Tape cutter product specifications: Size: 1.3M / 1.6M
■Model: GL-704B
■Power supply: AC100V or 230V 50/60Hz
■Setting range of tape length: 30 to 999 mm (in 1 mm position)
■Applicable tape width: 7~50mm
■Maximum tape outer diameter: 150mm
■Packing unit: 1 set

Inner core I.D.:  1"-3"

Min. Cutting width: 1mm 

Laser Cutting Machine Price

Semi-automatic cutting machine technical operation rules

4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com