Carbon Fiber Cutting Machine

Carbon Fiber Cutting Machine

Tape Cutting Machine - related instructions

         The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
         The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.

Carbon Fiber Cutting Machine

The difference between the scope and model of the tape cutting machine

Adhesive paper cutting machine M-3000-NMSR

Features:
It has the function of setting 3 different lengths. The configuration has an up-down counter.
Most suitable for independent production. Suitable for neutral production lines. Various adhesive tapes that are commercially available can be used. Automatically transfer and cut automatically in a certain size.

Specifications:
Tape width: 20mm-75mm
Tape length setting range: 40mm-999mm Maximum tape outer diameter: 210mm
Power supply: AC 230V 50/60Hz (110V, 117V is also available)

Carbon Fiber Cutting Machine

Semi-automatic cutting machine technical operation rules

5. Control and monitoring methods for mechanical process parameters and characteristics
5.1 When installing the cross rail and main rail, pay attention to the adjustment screw should not be too tight or too loose. 5.2 The cutting tip should be installed so that it should not be tightened too tightly, no air leakage.
5.3 Before using the suction-type torch, the gas injection must be checked and pressed with the finger on the acetylene inlet valve head. Then open the oxygen valve and the acetylene valve. If there is suction on the finger, it means the torch is normal and can be used. If there is no suction, or oxygen flows back from the B-connector, the torch performance is abnormal and must be repaired.
6. Provisions for mechanical supervision and inspection
6.1 The cutting machine should pay attention to the good condition of each part in normal use, and solve the problem if it is found in time.
6.2 Strengthen maintenance and repairs should be carried out every year.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com