Tape Cutting Machine - related instructions
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.
The difference between the scope and model of the tape cutting machine -
Adhesive paper cutting machine CELL-1000
If you forget to install the tape with automatic reminder function, and with the counting function, the set data will automatically stop at the end, remind the music to sound, and automatically light up. There may be a variety of tapes on the market.
Tape width: 7mm-50mm
Tape length setting range: 20mm-999mm Maximum tape outer diameter: 170mm
Power: AC100V 117V 230V can be corresponding
Semi-automatic cutting machine technical operation rules
7. Regular inspection of accuracy and variability
7.1 Detect the positive and negative turbulence of the main motion clutch after it is closed. The value is less than 2.0mm.
7.2 Detecting the running speed adjustment range of the host: the minimum speed is not more than 50mm/min, and the maximum speed is not less than 120mm/min.
7.3 Detecting the gas path part includes the connection of the connecting hose: air tightness: oxygen closed circuit 1.2Mpa, mixed gas path: 0.6 Mpa voltage regulation for 20 seconds shall not leak.
7.4 Detecting the thickness range of the cut steel plate: 10-100mm is acceptable.
7.5 Flame burning test of the torch (visible cutting oxygen flow length): 1#≥70mm; 2#≥90mm;3#≥100mm.
8. Daily maintenance regulations
8.1 After cutting the mouth, pay attention to the protective cover of the fashion, and do not bump.
8.2 Pay special attention to moisture when using and storing.
8.3 The lubricant in the gearbox should be replaced in time.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc