Tape Cutting Machine - related instructions
The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.
-------Suitable for cutting BOPP tape, PVC insulation tape, masking tape, double sided tape, duct tape, medical tape, etc.
1. Main driving part: Siemens AC motor with inverter is employed.
2. Operating panel: All functions are operated on the 10" LCD touch panel.
3: Motor control system: The central control system is PLC programmable controller.
4. Central control unit: Programmable central control is used and 20 sizes can be set on the same shaft for auto transfer and cutting.
5. Blade feeding positioning system: Blade feeding is controlled by Mitsubishi servo motor,and the cutting speed is adjustable in three stages.
6. Auto angle adjustment of circular blade: Mitsubishi servo motor is used to calculate the circular blade angle and the angle change is subject to different materials (the angle change range is ±8°).
7. Quick shaft change system: Three kinds of shafts are available and quick change of shafts is applied for different materials.
8. Cutting positioning system: Cutting positioning is controlled by Mitsubishi servo motor. The imported high precision ball screw is applied to set the size and the linear slide rail is to bear the load of the cutter seat.
Automatic double sided adhesive tape cutting machine:
This machine is suitable for kinds of adhesive tapes or kinds non-viscous material high precision cutting.
Such as the protective film, high tempreture tape, 3M tape, optical film, foam tape, goldfinger tape, green tape and other electronic material.
You can cut different sizes according to different material.
7. Round knife Angle adjustment system ( optional): The Mitsubishi servo motor control to calculate the circular knife Angle.According to different materials to do different angles change (adjustment range: + / -8 ° ) .If the cutting surface is not good, you can change the cutting Angle according.That will increase the production efficiency.
8. Automatic roll changing system (optional): The cylinder drive positioning gear to drive the active spline.Make sure the fast and accurate change of log roll but without stopping during cutting,
Save the loading and unloading time and increase the productivity.
9.Fast cutting shaft changing system (optional): 3 different size cutting shafts for optional.
You can cutting different size paper core log roll in the fast shaft changing device.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc