Tube Laser Cutting Machine

Tube Laser Cutting Machine

Tape Cutting Machine - related instructions

         The tape cutting machine has a counting and cutting length setting function. When using it, the tape should be placed in the tape cutting machine. The tape head should be pulled, then the power is turned on, the switch is turned on, and the setting is set according to the requirements. After that, press the yellow button on the right (start button), and the tape cutter starts to run and cut.
         The tape cutter cuts only a piece of tape at a time, and the cut tape is spit out at the gate. The sensor is installed at the gate. If the tape is not removed, the tape cutter will always be in a stagnant state. When we remove the tape, the tape The cutter will start automatically and cut the next tape. Cycle back and forth.

Tube Laser Cutting Machine

Automatic adhesive tape log roll cutting machine:

Product Application

Automatic adhesive tape log roll cutting machine is designed to cut large diameter foam tape,double sided tape,masking tape ,non-woven tape,protective tape ,PET,PE electric protective tape, and all kind of adhesive tape from large width cut into small width.

Main Features

1) Main driving part : Using AC motor with inverter is employed ,the acceleration and the deceleration are fast and steady .

2)Silicon solution cooling system, avoiding cutter getting sticky which can make sure that the cutting process are all right. 

3) Accurate cutting position: using servo motor to drive, used with perfect ball screw, linear or bit to make sure the cutting process accurate and perfect. 
4) The face and back tube are supported by oil pressure to ensure the stability of mini    pathway when it was cut.

5) Round knives cutting promotes the working efficiency. 

6)Cutting feed positioning system : Servo motor control ,3 phase speed feed ,improve efficiency and get best quality .

7)Setting a variety of sizes coaxial and automatically converts cutting .

Tube Laser Cutting Machine

China factory bopp adhesive tape rewinding/slitting/cutting machine:

Product Application

I.MAIN TECHNICAL PARAMETERS OF bopp tape slitting machine
1.1.Suitable base material: BOPP tape;
1.2.Valid width: 1300--1600 mm;
1.3.Maximum unwinding diameter: 800mm;
1.4.Maximum winding diameter: 150mm, four-position winder; 320mm, two-position winder
1.5.Diameter of paper core: 3”
1.6.Splitting width: 12-1580mm;
1.7.Mechanical speed: 0-180m/min;
1.8.Electricity: 380V, 50HZ;

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com