Automatic tape cutting machine - Introduction:
The tape machine, also known as the tape cutter and tape cutter, is an object that can support a roll of tape and has mechanical means on the other end for cutting the tape. The cutting machine is divided into many types depending on the type of tape to be cut. The most common and most common are clear plastic cutting machines (like those often used in the office or at home), made of plastic; some may be consumables. Other tape cutters are fixed, and some machines have complex functions to control the feeding and cutting of the machine and are also ergonomic in use.
The difference between the scope and model of the tape cutting machine -
Adhesive paper cutting machine M-3000-NMSR
It has the function of setting 3 different lengths. The configuration has an up-down counter.
Most suitable for independent production. Suitable for neutral production lines. Various adhesive tapes that are commercially available can be used. Automatically transfer and cut automatically in a certain size.
Tape width: 20mm-75mm
Tape length setting range: 40mm-999mm Maximum tape outer diameter: 210mm
Power supply: AC 230V 50/60Hz (110V, 117V is also available)
Semi-automatic cutting machine technical operation rules
4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc