Laser Label Die Cutting Machine

Laser Label Die Cutting Machine

Handheld Tape Cutting Machine - Introduction


      Some tape machines are small, and the tape machine and tape can be taken together where they are needed. This type of tape machine can easily cut the tape and the user can easily use the cut tape. It allows to be taken wherever the user wants to use it.

Laser Label Die Cutting Machine

The relationship between the tape cutting machine and the tape -

2: The tape mainly includes single-sided tape, double-sided tape, industrial tape, electronic tape, medical tape, acrylic tape, rubber tape, and silicone tape. The main substrate of the tape is paper, cloth, film, etc.; the support of the tape cutter is mainly a release paper, a release film, etc.; the adhesive has an acrylic adhesive, and a rubber adhesive. Substrate and support physical property testing focuses on basis weight, thickness, elongation, and release force; the focus of adhesive property testing is viscosity solid content. The physical properties of the tape are measured by coating amount, coating thickness, adhesion, holding power, adhesion from the back surface, drawing force, initial adhesion, weather resistance, heat resistance, solvent resistance, electrical conductivity, flame resistance, and the like.

Laser Label Die Cutting Machine

Semi-automatic cutting machine technical operation rules

4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.

About

Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?
CALL US NOW

+86-17744612788

gl006@guolianjixie.com