Semi-automatic tape cutters are usually divided into three categories:
Lightweight: for simple, non-industrial use
Industrial: A relatively solid paper cutter means you can work more than 8 hours a day.
Heavy-duty: The most solid automatic tape cutter, which can withstand continuous use 24 hours a day, 7 days a week.
The difference between the scope and model of the tape cutting machine -
Protective film cutting machine TDA080-NMSR
It has the function of reducing the wrinkles and indentations generated by the roller on the protective film and the aluminum foil tape. Configure specially machined smooth rollers.
It has anti-static effect and can prevent the tape from adhering to the machine casing. Specialized heavy duty cutting machine for industrial use. Suitable for work of more than 8 hours a day.
A machine that uses metal parts and metal parts for maintenance and repair. Automatically transfer and cut automatically in a certain size. A grounding wire is required for the included 3-pin plug body.
Tape width: 13-80mm
Tape length setting range: 40-9999mm Maximum tape outer diameter: 230mm
Power supply: AC 100V 50/60Hz (117V, 230V is also available)
Semi-automatic cutting machine technical operation rules
4. Mechanical operation
4.1 All parts must be carefully inspected before use and then tested. At the same time, check the gas distribution valves and torches and the connection path. If there is no problem, ignite and observe whether the flame is normal. If there is no problem, it can be cut.
4.2 When cutting straight lines, it is necessary to put a special track on the steel plate to be cut, select the cutting nozzle according to the cutting thickness, and adjust the speed before cutting.
4.3 Pressure automatic switch and pneumatic valve are normally open. When using automatic pressure switch, the knife switch at the label pressure switch should be pointed in the direction of closing. At this time, the pressure automatic switch is turned on during cutting. When walking, if the automatic switch is not used, the knife switch is pointed to the open position, so that the operation and stop of the cutting machine can be controlled only by controlling the on/off of the power label.
4.5 When cutting the circle, the radius rod should be installed in the screw hole of the body shell and locked, then the tip of the fixed needle should be placed in the hole of the pre-cut center, and the fixed needle can be adjusted to lift the cutting wheel of the cutting machine. To cut, if you need to cut the groove, you can reach the torch by turning it through a certain angle.
4.6 The forward and backward movement of the cutting machine (ie, forward and reverse operation) can be controlled by controlling the middle and reverse signs.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc