GL-5000 tape cutter to cut two kinds of tape at the same time steps and precautions
If the tape width is less than 10 mm, insert the divider. This model can cut two tapes with a width of less than 25 mm at the same time.
1. Remove the divider from the bottom of the machine.
2. Press the press cover button to open the press cover.
3. If the tape width is less than 10 mm, insert the auxiliary spacer.
! Remove the auxiliary divider from the bottom of the machine and insert it into the junction of the divider.
4. Install the tape roll and move the width bar to adjust the tightness of the guide plate.
5. Import the tape and set the working mode.
! In the automatic mode, when cutting two sets of tape, take two pieces of tape and the machine will cut the two pieces of tape.
1. Forcibly cutting high-adhesive tape will affect the service life of the motor.
2. After using the divider and auxiliary dividers, return to the bottom of the machine.
China factory bopp adhesive tape rewinding/slitting/cutting machine:
I.MAIN TECHNICAL PARAMETERS OF bopp tape slitting machine
1.1.Suitable base material: BOPP tape;
1.2.Valid width: 1300--1600 mm;
1.3.Maximum unwinding diameter: 800mm;
1.4.Maximum winding diameter: 150mm, four-position winder; 320mm, two-position winder
1.5.Diameter of paper core: 3”
1.6.Splitting width: 12-1580mm;
1.7.Mechanical speed: 0-180m/min;
1.8.Electricity: 380V, 50HZ;
Suitable for BOPP tape,PE,PET,masking tape,double-side tape,release paper and many other adhesive tape and non-adhesive tape.
1)Main driving part:Taiwan AC motor with inverter is employed.
2) Central control unit:Programmable central control is used and 20 sizes can be set on the same shaft for auto transfer and cutting
3) Operating panel:All functions are operated on the 10" LCD touch panel.
4) Motor control system:The central control system is PLC programmablecontroller.
5) Cutting positioning system:Cutting positioning is controlled by Mitsubishi servo motor. The imported high precision ball screw is applied to set the size and the linear slide rail is to bear.
6)Blade feeding positioning system:Blade feeding is controlled by Mitsubishi servo motor,and the cutting speed is adjustable in three stages.
7) Auto angle adjustment of circular blade:Mitsubishi servo motor is used to calculate thecircular blade angle and the angle change is subject to different materials (the angle change range is ±8°).
8)Quick shaft change system:Three kinds of shafts are available and quick change of shafts is applied for different materials.