Rewinding Machine operating procedures - Job preparation.
1. The operator arrived at the post 10 minutes in advance.
2. Check and understand the operation of the equipment, check equipment hazards, check equipment hygiene and on-site hygiene, and make a good inspection record.
3. Understand the production situation and quality of the class before the class, familiar with the work site.
4. Familiar with process standards, master product quality requirements, variety specifications, dimensions, roll length, indicators and tasks.
5. Do personal safety protection and equipment safety protection.
6. Carefully implement the handover system and make a record of the handover.
Four release and one rewinding machine operation program ---
Fifth, sorting out
1. After the work is finished, turn off the power and put the main power switch down.
2. Clean up the work area.
1. It is necessary to add oil to the bearings.
2. Use a manual grease gun to add butter to the bearing of the belt shaft once every six months; when the gear is missing butter, pay attention to add butter.
1. The winder has certain dangers, so it is necessary to pay attention to safety during operation.
2. Never touch the ultrasonic probe on the pressure roller.
Rewinder mechanical structure and control process ---
Second, the main structure of the winder
2.2 Longitudinal section
In the mechanical system of the winder, the slitting mechanism is a very important part of the winder. In order to ensure a straight and smooth cutting edge, the quality control of the finished paper roll plays an important role in ensuring the volume. It is easy and can reduce the fluffing during printing. The slitting mechanism should be installed as close as possible to the paper roll so that it can produce a lateral movement more than necessary during the process of cutting the web without curling.
The high-speed rewinding paper conveying system is also very important in the application. The old-fashioned rewinding machine is mainly handled by manual. With the increase of the speed of the rewinding machine, the manual can no longer be processed. There are two ways to transport the paper side of the reel: fan direct pumping and venturi suction. The direct drawing type of the fan mainly uses a centrifugal fan, and the fan is placed under the floor. The inlet of the fan and the air duct near the longitudinal cutting edge are connected to each other, and the blade of the fan is also equipped with a wind blade. When the fan is sucked, it will be broken by the blade and then sent to the water pulper. However, since the edge of the paper has to pass through the inside of the fan, the blade transported by this type of paper is very worn and needs to be changed frequently. Venturi suction is also used in the high-pressure centrifugal fan, but the paper edge does not pass through the fan, directly the longitudinal cutting edge of the duct into the venturi pipe, the wind machine generates negative pressure in the venturi, and then the paper While washing the venturi tube and then feeding it to the water pulper, the paper edge conveyed at this time is continuous. The disadvantage of this method is that when the speed of the winder is relatively high, the power of the selected fan is large, which will increase the operation. Cost, increase loss.
Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc