Maskingtape Slitter Rewinder

Maskingtape Slitter Rewinder

Rewinding Machine operating procedures - Unwinding paper core
(1.) Post operator
1. First check the cutting distance of the measuring cutter, which is consistent with the specifications required by the process standard.
2. Before placing the paper core, first check whether the paper core used meets the requirements for use:
A. Is the size of the specification the same as the roll paper size?
B. Is the inner diameter and outer diameter of the paper core acceptable (the thickness is consistent).
C. Does the strength of the paper core meet the requirements?
D. Whether the port is layered or burred.
E. Can be put on the machine after passing the inspection and passing the test.
3. Signal the main operation: Start the ejector pin pump button and insert the paper core onto the ejector cone.
4. Shake the two thimble handles to the left to push the core.
5. Align the edge of the paper core port (the difference between left and right cannot exceed one millimeter).

(2) Main operation
1. Review again whether the paper cores on the board meet the requirements.
2. Review whether the thimble is inserted into the lock (avoid the end of the paper roll is not aligned)
3. Check the sharpness of the upper and lower round knives, the depth of the occlusion and the angle to ensure the quality of the trimming.

Maskingtape Slitter Rewinder

Guolian Small Winder Introduction---

First, the function: a variety of tape defective products re-rolled
Second, the characteristics:
A. The take-up shaft is driven by a DC 1HP motor and can be steplessly changed.
B. Automatic counting, convenient for setting the length of the winding.
C. The rewinding tension is adjusted by the spring, and the tension adjustment is convenient.
D. The structure of the machine is light and compact, and it is a desktop device, which is convenient to move.

Third, the specifications
1. Roller surface width: 105mm
2. Maximum discharge diameter: standard is 150mm and length is 400mm
3. Take-up diameter: Ø76mm-300mm
4. Rewind width: 12mm-100mm lengthening type is 300mm
5. Take the paper heart: paper tube 3”
6. Mechanical speed: 0~150M/min per minute

Fourth, the host configuration
1. Discharge shaft: 3" movable type (1)
2. Dispensing rack: lengthened 300mm diameter (1)
3. Main motor: DC motor 1HP (1 set)
4. Take-up tension: Spring control (1 set)
5. Length control: four-digit electronic counter (1 group)
6. Take-up shaft: 3" tube core (1 group)

Maskingtape Slitter Rewinder

Automatic rewinding machine speed ratio adjustment method ---

4. Adjust the internal toothed chain and external chain of the main gearbox to make the transmission of the whole machine more stable. When the roll paper rewinding machine is running, it is controlled by the automatic acceleration and deceleration program to start and stop frequently, and the automatic trimming and sealing operation is completed. Therefore, the stability of the gearbox transmission ratio is high. By tightening its internal and external chains, the chain can be prevented from slipping and skipping, making the speed ratio more stable during frequent acceleration and deceleration. The tensioned upper chain of the toothed chain can be moved up and down by a tool of about 5 to 8 mm.


Zhengzhou EAST IMPORT AND EXPORT co., ltd . ( a goulian group of company) a manufacturer and exporter for all kind of packaging machinery , like bopp tape coating machines, bopp tape slitting machines. Bopp tape core cutter, bopp tape core loader etc

Got any Questions?